Type: Posts; User: Demontang
I'll try and run and get pics tonight
I'll have to go look at it again to be sure but believe it was 3.55 ratio, the pass side inner/outer axle, spindle and maybe the caliper. I have a rotor and some misc parts around for it I'll have to...
Got a n 9" third member with 4:10 gears and a standard third with lock rite and 3.55gears.
Lol I've got a 74 bronco fron Dana 44 housing minus the axle and spindle of one side. I'll have to see what else I still got for that still of bronco. Got a Holley 4v think it's 4150
Man this is exactly what I need well the adapter from trans to tcase. Any thing else you would take for trade?
It a shot gun and a good one too :)
I want to fondal one before I get it lol. I also just saw the xds 45 and it looks like something I might want as well. I carry a xd 45 4" and want some thing easier to hide in the warm summer months....
Let me know if you get a xdm 45 3.8 :)
Lol no nothing now it's been put on back burner since the rear end just blow in the expedition:(
So the motor mount is made and the motor and trans are bolted together now I need to fab up the trans crossmember.
MOtor bolted in
I think it's power.
Test fit mounts which didn't work. Now it's time to fabricate them.
Got the 351 pulled and the trans/transfer. Hopefully I'll have the motor cleaned and put in the ranger tomorrow.
I'm taking the motor trans and transfer plus the engine wiring and computer. Need some parts?
I think I'll have to done in a week but will need to take on the axles after that lol
Got the donor bronco fired up and loaded. Also started pulling it
So fired off the 351 I should have the bronco loaded up and motor/trans pulled by sat. I hope that I'll have it cleaned new gaskets on it and mocked up in the ranger by Monday.
The coyotes out stay away from the roads 99% of the time. I've always avoided the areas people shot toward.
I always pack out crap when I go out. And it's not just target shooters that dump out there but people are dumb enough to shot that stuff.
It amazes me how that expedition can pull 8500lbs. The ranger is 6200 and trailer was 2300, I'm loving that 5.4 I can wait to see how the ranger does with the 351w. I'm lookin in to getting the axles...
Well I took the ranger in to pull the 4.0 out and get it ready for the 351w.
If only it where a ford.
Sweet Love rc cars myself. Nitro cars are race not crawlers and by no means are dieing off. Look at selah rc raceway Ron, if you need help tuneing hit me up I use to race them and even did a lot of...
Got the cam/ head combo picked out. If I run the ported cast head I should get 360-370hp with 380ftlb and if I put aftermartket head on it 400-450hp and 450+ftlb :headbang: Or so the dyno spread...